emenaman

I had issues with mine, nothing was sticking to it causing 100% failures. I forgot where I read it but I ended up scrubbing it good with one of those slightly abrasive green pads in warm dawn dish soap, drying it with a clean microfiber cloth and putting it on the bed with the heat set to 60c for a few minutes. It now works extremely well with pla or petg, I just wipe it down with a bit of 90% alcohol between prints. Never had any issues with the smooth and satin sheets.

I remember them raiding the smaller farms back in the 80s. The owners struggle to continue to make any type of profit and sell out to the bigger corps. Then in a few years they are back to employing these so call immigrants. I believe this is all just class warfare.